
Installing and Removing the Control
U
nit from Camera.
1.
Push the Power Control's hot shoe base fully into the camera hot shoe.
2.
Rotate the Hot Shoe Locking Ring to tighten it according to the direction indicated by the arrow. Do not over-tighten.
3.
To remove the Power Control, loosen the Hot Shoe Locking Ring and slide the Power Control off of the camera hot shoe.
Note: If the camera's built-in flash is in pop-up state, tum off the flash and then install the power control onto the camera.
When installing or removing the power control, hold the flash power control bottom to prevent damage to hot shoe bases
of the camera and power
control.
-4-