DLC COVERT II, Instruction Manual, Page: 9 / 32

Page 9
3.5 Connecting the Remote Control Keypad and Entering into the SETUP Mode
Entering into the SETUP mode: Anytime in the LIVE mode, the SETUP mode
is activated when inserting the remote control keypad into the keyboard interface
of the
DLC COVERT II
(If a picture or a video has just being taken, this action will be
finished first).
In OFF mode you just need to connect the remote control keypad into the
keyboard interface of the
DLC COVERT II
and power on the
DLC COVERT II
if the
SETUP mode is needed.
Under the SETUP mode you can change the settings on the
DLC COVERT II
manually or set operational parameters with the help of a display, i.e., the built-in
LCD or an external TV monitor.
3.6 Manual Capture
Under the SETUP mode, you just need to aim at the object, and then press the
SHOT key. A few seconds later, you’ll get a picture saved in the SD card. The
number of pictures and video clips at the bottom of the LCD will increase by one.
3.7 Default Settings and Live Monitoring
When the
DLC COVERT II
leaves the factory, most parameters are set as default.
Please refer to table 1.
Parameter name Default Other settings
Camera Mode Camera Video
Image Size 3M Pixel 5M Pixel
Video Size 64
0×
480 320x240
Capture Number 1 Photo 2 Photo, 3 Photo
Video Length Avi 10 Second 1-60 seconds
Interval 1 Minute 0-59 seconds, 1-60 minutes
Sense Level Normal High, Low
Time Stamp On Off
Timer Switch Off On (00:00 – 23:59)
Table 1: Default settings of the DLC COVERT II