IPLoC D2-POM - User Guide 2015-12-01. Ver. 1
Specifications are subject to change without notice.
DKT is not responsible for any typographical errors or wrong.
Page 7
Installing IPLoC D2-POM
The IPLoC D2-POM can be installed into any home with coaxial cables by simply connecting
the device to a coaxial cable outlet as the IPLoC D2-POM is pre-configured with default
parameters that will allow operation without any additional configuration. Up to 16 units
is possible in a MoCA network.
Below we will go through some installations examples of IPLoC D2-POM for creating a
Ethernet network over coax.
Minimum installation
Practical installation of a IPLoC unit
Overview
Coaxial Cable, maximum length 100m
Router
Computer
Using 2 pcs of IPLoC with a single coaxial cable for
distribute Ethernet signal.
This is not a normal way, only to show minimum
configuration of a MoCA coax network.
• Find the TV-Outlet that is nearest your home
router and install your first IPLoC D2-POM
there.
You also need a 220V outlet for the power
supply.
• If you have a antenna cable in the outlet to
a TV set, remove that and push on the IPLoC
D2-POM and re-install the TV-set cable in the
IPLoC D2-POM unit
• Connect the power supply unit.
The diode for power will light up green.
• Connect a Ethernet patch cable between your
home router and IPLoC D2-POM.
• Find your second TV-Outlet and repeat the
procedure but instead of a router connect to
your other items that need an internet con-
nection, such as a Smart-TV.
• When you have powered up your second IPLoC
D2-POM there should be a green MoCA diode
and LAN diode if everything is ok.
Note! It can take up to 3 minutes before
there is a link.
Ethernet
Patch Cable
Ethernet
Patch Cable
Internet
Summary of Contents for IPLoC D2-POM
Page 1: ...IPLoC D2 POM User Guide...