1835-065-J-7-14
44
3.7 Programming Four-Digit Entry Codes
Four-digit entry codes are entered
ONLY
on the
Telephone Entry System Keypad
preceded by “ # ” to allow the resident access.
DO NOT
confuse a
FOUR-digit ENTRY code
with a
FIVE-digit DEVICE code
that is entered on a remote wiegand keypad
(see
previous page).
Each entry code that you enter must be assigned to a directory code that you select (that was programmed in section 3.5.2).
Only
ONE
entry code can be programmed for each directory code.
You cannot duplicate entry codes.
1.
Press and enter your four-digit MASTER CODE (
beep
).
2.
Enter the existing
directory code
(section 3.5.2 or 3.5.4) that the entry code will be assigned to (1, 2, 3 or 4 digits, section
3.5.1), then press (
beep
).
3.
Choose and enter a
four-digit entry code
, press (
beep
).
4.
Repeat steps 2 and 3 to enter additional entry codes. (You cannot duplicate entry codes)
5.
Press together to end this programming sequence (
beeeeeep
).
??
??
??
??
22
ABC
ABC
00
OPER
OPER
00
OPER
OPER
3.7.1 Programming Four-Digit Entry Codes
Four-digit entry codes can be made to activate relay 0, relay 1, or relay 2 or any combination of relays by programming
HI
and
LOW
ranges for each relay. Ranges between relays may overlap, which will cause more than one relay to activate if this is
desired. For example, if the low boundary for relay-0 and relay 1 is 2000, and the hi boundary is 3000 for relay 0 and 4000 for
relay 1, then entry codes between 2000 and 3000 will activate both relays, and entry codes between 3001 and 4000 will only
activate relay 1.
3.7.3 Entry Code Ranges
1.
Press and enter your four-digit MASTER CODE (
beep
).
2.
Press (
beep
) to set
relay 0
, or (
beep
) to set
relay 1
, or (
beep
) to set
relay 2
boundary.
3.
Enter the
four-digit LOW boundary
, then press (
beep
).
4.
Enter the
four-digit HI boundary
, then press (
beep
).
5.
Repeat steps 2, 3, and 4 to set the other relay boundaries.
6.
Press together to end this programming sequence (
beeeeeep
).
??
??
??
??
2
2
ABC
ABC
11
SP
SP
00
OPER
OPER
00
OPER
OPER
11
SP
SP
22
ABC
ABC
1.
Press and enter your four-digit MASTER CODE (
beep
).
2.
Enter the existing
directory code
(section 3.5.2 or 3.5.4) that the desired entry code has been assigned to (1, 2, 3 or 4 digits,
section 3.5.1), then press (
beep
).
3.
Enter , then press (
beep
).
4.
Repeat steps 2 and 3 to delete additional desired entry codes.
5.
Press together to end this programming sequence (
beeeeeep
).
??
??
??
??
22
ABC
ABC
00
OPER
OPER
00
OPER
OPER
3.7.2 Delete Entry Codes
Summary of Contents for 1833 Series
Page 2: ......
Page 69: ...1835 065 J 7 14 67...
