DKM Motor GEARHEAD, User Manual

Page: 15 / 20

12
* Overhung load values for hollow shaft models are measured at
10mm distances from the fl ange mounting surface.
·
Overhung load values are measured at 10mm distances from
shaft end.
·
Do not exceed the torque of overhung load and thrust load
at the same time in case of uses of helical gear or worm gear is
employed as transmission equipments.
·
Also, place the load to close in gearhead in case of connecting
the load to output shaft directly to avoid to loaded in one side.
Install the structure as (Figure 3-1) in case of overhung load is
over the torque in chart.
3.3 Max. permissible torque of gearhead
Permissible torque is limited by material although the output
torque of the gearhead is in proportion of gear ratio. It calls max.
permissible torque and determined by size of gearhead and gear
ratio.
3. Caution Point in Operation