v.190915
En.11
ENGLISH
TROUBLESHOOTING
Plow is not func
Ɵ
oning:
1. Con
Į
rm the main power and control wire plugs are clean and properly connected
2.
Con
Į
rm the control wire is properly connected to the hand held control.
3. Con
Į
rm that the main power inline breaker was not accidently tripped. Press the red bu
Ʃ
on on top
and push the trip wing back in to reset
Not the
Į
rst three…
4. Do a quick test of the hand held control, standing between the snowplow and the vehicle on the
passenger’s side unplug the grey control wire at the rubber plug assembly, leave the main power plug
connected, with the use of needle noise pliers perform the two oper
ĂƟ
ons shown below on the plow
side of the plug. Try raising
Į
rst and the pump should run, then lower.
To raise the plow…
To lower the plow…
A - If the plow operates there is an issue with the control or control wire, check the wire carefully to make sure it
is not cut or pinched, remove and reconnect the wire from the bo
Ʃ
om of the hand held control, re-connect the
control wire to the plow and re-test.
