Power supply
You can operate this device with the mains voltage of AC230V~ / 50 Hz, or with battery
power.
Mains operation
Connect the mains cord to a properly wired wall outlet with a voltage of AC230V~ / 50 Hz.
Now the device is operational.
Battery operation
Open the battery compartment on the rear side of the unit. Insert 8 x 1.5V UM-2 R14 „C” size
batteries (not supplied) into the compartment according to the insertion instructions in the battery
compartment. Observe the correct polarity of the batteries, as otherwise the device may suffer
damage. Due to their longer service life, we recommend you to use alkaline batteries. Close
the compartment again. Now the device is operational.
Batteries must not be thrown in the household waste. Please take used batteries
to the respective collecting points or take them there where you have bought the
new ones. Do not throw batteries into the fire.
General operation
Move the FUNCTION switch to choose the desired function.
Ø
"CD” for CD playback, or
Ø
"RADIO” for radio reception, or
Ø
"TAPE (OFF)” for cassette operation.
To switch the unit off, move the FUNCTION switch to the „TAPE (OFF)” position.
With the VOLUME controller at the left side of the unit you can set the volume as requested.
Turn the controller clockwise to increase the volume. Turn it counter clockwise to lower the
volume.
If you would like to boost the low frequencies, press the
DBBS
button. Press the button
again to deactivate this function.
Headphone Operation
You can connect a headphone to the PHONES jack at the rear end left in the device using a
3.5mm jack plug. This deactivates the build-in speakers.
Be careful with regard to your hearing. A too high volume may lastingly impair the
hearing ability of your ears.
5
