32
OPERATION
ENTERING AND CHANGING THE PIN
To gain access to any part of the Vectra® Genisys Laser unit, you must enter a Personal Identification Number (PIN). The unit is
shipped with a default PIN that allows you initial access, but you may change the number anytime. To enter and change the PIN, do
the following:
1.
Turn the system power “ON” by pressing the Power On/Off button.
The unit displays the message “Initializing System.” Then, the Enter PIN window displays.
2.
1 1 1 1 is the default PIN. Press the button representing the number 1 four times
so
that
* * * *
displays briefly.
The main window displays.
If you enter the wrong PIN, the message “Incorrect PIN was entered. Please try again. Press
any key to continue” displays. Press any key on the Operator Interface.
NOTE:
If you lose or forget your PIN, contact Chattanooga Group Service Department at
(866)
864-0598
or
(423)
870-2281.
Vectra® Genisys Laser
