www.dji.com
O
SMO
1. Install the DJI GO App
Search for ‘DJI GO’ on the App Store or Google
Play, and install the app on your mobile device.
3. Mount your Mobile Device
4. Unlock the Gimbal
1. Rotate the tilt motor
2. Rotate the roll motor
SmoothTrack Mode is enabled automatically
to smooth out jerky movements.
The Osmo will beep slowly if the gimbal is
locked after it is turned on. This means the
camera is working normally but the gimbal is
shut off.
If you need to unlock the gimbal after it is
turned on, you must rotate the pan motor after
unlocking the tilt motor and pan motor to
reactivate the gimbal.
5. Connect to the DJI GO App
For more information, read the User Manual:
www.dji.com/product/osmo
2. Prepare the Battery
Fully charge the battery for the first time to activate.
Insert the battery as shown.
6. Controls
Follow the order above to avoid damaging the camera.
Rotate the motors just enough to loosen them.
3. Slide the Pan Axis Lock up
※
This Quick Start Guide is subject to
change without prior notice.
DJI GO supports iOS 8.0 (or later)
or Android 4.1.2 (or later).
Charge Time: ~1 hour.
The LED indicator will glow green when charging is
complete.
Ensure your mobile device is fully seated.
High Low
Battery Level
Designed by DJI. Printed in China
©
2015 DJI. All Rights Reserved.
Activate the Osmo if you are using it for the first time.
This requires an internet connection.
Internet
Unfold the arms
Adjust the pads
Launch the app and tap
Enter Camera View.
Turn on your mobile's WiFi and
connect to
OSMO_XXXXXX
Default password:
12341234
OSMO_XXXXXX
To Power On:
Pull down on the switch
Pull down again > Sleep
Pull down and hold for 1.5 s > Power Off
●
Position the camera
directly by hand.
●
Trigger
Hold down to enable Lock Mode.
Tap twice to center the camera.
Tap three times to enter Selfie
Mode.
●
Pan or tilt the camera with
the joystick.
Place one end
Place the other end
Pull outwards
●
Record Button
Press once to start recording,
and again to stop recording.
●
Shutter Button
Press once to take a photo.
Rotate to desired angle
