6
©
2020
DJI All Rights Reserved.
EN
e. Connect the cable to the Reserved Expansion Port 2 (7-pin) on the bottom of the aircraft body.
Usage
1. Open the cover of the spread tank as shown, add compatible materials, and close the cover.
M3×12
M3×12
M3×10 (Plus)
135 mm
2. Power on the remote controller, and then power on the aircraft.
3. Enter Operation View in the app.
4. To set the hopper outlet size, spinner disk rotating speed, and flying speed, tap the
Spreading
Settings
button
89%
, which is located towards the top of the interface. Adjust the settings so
that they are suitable for the materials you are using and test to make sure the performance is as
expected.
For the Spreading System 1.0, when measuring between 7.5 to 9 kg/ha of materials spread, it is
recommended to:
• Adjust the hopper outlet size so that the material delivery rate is 1 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range is 4 to 6 meters.
• Set the flying speed to 4 m/s (flying speed setting is unavailable in Manual Operation Mode).
For the Spreading System 2.0, when measuring 45 kg/ha of materials spread, it is recommended to:
• Adjust the hopper outlet size so that the material delivery rate is 8 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range is 5 to 7 meters.
• Set the flying speed to 5 m/s (flying speed setting is unavailable in Manual Operation Mode).
5. Enter the operation mode required for spreading. The operations of the Spreading System vary
depending on the operation mode.
