31 |
P a g e
4.2.2
Test 2 Heating:
Click the
Bed
and
Extruder
buttons highlighted below, this should start heating up
the components. Start out at 50ºC for both components and increase the
temperatures 10ºC at a time until all is confirmed working.
Use the following guide for temperatures:
•
PLA:
Hotend: 180ºC
–
200ºC Bed: 40ºC
–
50ºC
•
ABS:
Hotend: 200ºC
–
255ºC Bed: 70ºC
–
100ºC
Note:
Beware of hot components! Any sign of trouble, burning smell
etc. TURN OFF.
If either of the components does not heat up, refer to the troubleshooting guide.
Also ensure that the Bed and Extruder are not switched around, i.e. bed should
respond to bed temperature changes.
You can leave the components heated for the following tests.
