10 - AUDIO PROBE
L’audio probe è utilizzata come valido strumento
per il debugging dei circuiti e consente in buona
sostanza di seguire il segnale audio in input
lungo tutto il circuito, identificando dov’è che il
segnale si blocca ed aiutare nel risolvere even-
tuali problemi. La probe (3), che ciascuno può
costruirsi da sé, si compone come di seguente
(jack femmina da pannello mono, condensatore
da 100nF e puntale da tester o spezzone di filo
rigido per la probe):
The audio probe is used as a valid and effective
resource to debug electronic circuit for effect
pedals, allowing following the audio signal path
in the circuit from input to output and helping in
identifying where the problem in the circuit is
located.
The audio probe (3) can be assembled by anybo-
dy using the few described components: a
mono jack, a capacitor (100nF) and a multimeter
probe or a small piece of rigid electric wire for
the probe terminal itself:
First of all it is necessary to assemble the mono jack,
the capacitor and the multimeter probe or rigid
electric wire. After that the probe is connected to an
amplifier or speaker (1) using an audio jack cable (2).
1) Connect an audio source in input at the electronic
circuit to debug and turn the amplifier or the speaker
on: the audio source can be of different types (e.g.
mp3 player, an electric guitar);
2) Activate the electronic circuit (led on);
3) Follow the schematic of the electronic circuit from
the input to the output and position the probe on
different parts of the circuits to be tested. It is sugge-
sted to start from the input jack tip till the output jack
tip;
4) Once the probe is placed on a working trace/com-
ponent of the circuit, the amplifier will reproduce the
audio signal given in input at the electronic circuit;
5) If the probe is placed on a faulty trace/component,
no audio signal will be reproduced by the amplifier or
speaker: in this case it is necessary to intensify the
investigation around the faulty area;
6) What is the root cause of the issue? A faulty compo-
nent? A cold join?
7) In these cases it is necessary to replace the compo-
Una volta assemblati correttamente il jack mono
femmina, il condensatore da 100nF, il puntale o
filo rigido per la probe ed aver effettuato il colle-
gamento a massa, si procede collegando il tutto
ad un amplificatore per chitarra oppure ad cassa
acustica (1) tramite un cavo apposito (2).
1) Collegare una sorgente audio in input al circuito
elettronico (non alla probe): tale sorgente potreb-
be essere di qualsiasi tipo (per esempio un lettore
mp3);
2) Attivare il circuito elettronico che si sta control-
lando tramite 3PDT (led di stato acceso);
3)Seguendo lo schema del circuito elettronico,
seguire la traccia del segnale dall’input fino
all’output, posizionando la probe sui diversi punti
del circuito/componenti che si intende testare. Si
consiglia
di iniziare dal tip del jack di input, attraversare il
circuito fino al tip del jack di output;
4) Una volta sistemata la probe su una
traccia/componente funzionante, si sentirà
nell’amplificatore
o nella cassa acustica il segnale audio iniettato in
ingresso al circuito elettronico;
SHIELD
PROBE
GROUND
CAPACITOR
100nF
TIP
Componenti non inclusi nel kit/ Components not included in this kit
Summary of Contents for REPLICA Series
Page 9: ...6 SCHEMA ELETTRICO SCHEMATIC ...
Page 15: ...do it yourself it s better ...