Making tips
1. LED wiring indication:
White=Positive;Grey=Negative.
2.Use a craft blade to carefully
skim over the plastic to bare the
copper wire.
3. For LED wiring extension,
please refer to the below steps:
Twist the copper of
both LED wire and
extension wire
together.
Do the same on the
white wire.
Remarks: Tie a knot
at the end of the grey
wire to differentiate
the polarity.
Place the duly twist
wire on the tapes
provided.
Roll and wrap the
wire.
Place another wire
next to it.
Remarks: DO NOT
contact both copper
wire to avoid short
circuit.
Roll and wrap it together.
Warnings
The
product
is
not
suitable
for
children
under
14
years
old
.
The
should
be
under
custody
of
adults
when
playing
with
the
product.
There
are
small
parts
,
please
do
not
swallow
them
for
avoiding
dangerous
accidents
.
Tips
for
assembling
1.Picures shown on the package may
be slightly different from the actual
product.
2.Please use the provided tracing
paper for cutting purpose to achieve
the best
outcome.
3.Product designs and specification
may be subject to change without
advance notice for purpose of making
improvement.
4.Testing on LED function:
DO NOT contact the
LED wire end direct
to the battery cell.
Use the provide battery
holder. Make sue the
correct polarity.
1.Material and tools needed:
- Battery holder, LED bulb,
tape.
2.Twist the following wire together:
(I) WHITE wire from the battery box
with the GREY wire from LED bulb.
(II) GREY wire from the battery box with
the WHITE wire from LED bulb.
3.Wrap the exposed wire
with the tapes.
4.Tear off the rubber paper
Rubber paper
5.Set the black key on the
battery box to one side
of “ON” as shown.
6.Ture on the power and
complete the installation.
LED
wire
LED
wire
LED
wire
Extension
wire
How to assemble the battery holder
