Hikvision Intercom Setup Guide (v1.0)
September 2017
DIY Security Cameras (www.diysecuritycameras.com.au)
Page
3
2 Introduction
This guide will take you through the steps to setup a Hikvision Video Intercom system for a single dwelling with 2 x Indoor
Room Stations and 1 x Villa Door Station. This assumes that the Intercom devices are at factory default settings and need to
be activated.
3 Equipment
1 x KAD606 – Video/Audio Distributor
2 x DS-KH8301-WT – Indoor WiFi station
1 x DS-KV8102-IM – Villa Door Station
1 x PC/Laptop running iVMS4200 2.4.5.X
4 Pre-Requisites
4.1 Network
Worksheet
Before we begin we need to plan out our network IP addresses to be assigned to each of the intercom components to provide
connectivity. Any IP subnet can be used, however note that there can only be a maximum of 9 villa door stations in one
system, so leave enough address space to cater for this if required.
In our example we are going to use 192.168.20.0/24 subnet as per the table below.
Device
Type
Local IP
Subnet Mask
Gateway
Door Station
IP
SIP Server
Main Door
Type
Main Door
V Series
192.168.20.100
255.255.255.0
192.168.20.254
N/A
N/A
V Series
Master Indoor
Station
Indoor
Station
192.168.20.110
255.255.255.0
192.168.20.254
192.168.20.100
192.168.20.100
N/A
Extension
Indoor Station
Extension
Station
192.168.20.111
255.255.255.0
192.168.20.254
N/A
N/A
192.168.20.110
4.2 Firmware
The minimum firmware release for the intercom system is v1.4.0 Build 170302. Please ensure this version of firmware is
installed before proceeding with the remaining setup. To obtain the firmware please email us at
. Note we can only supply firmware to our customers.
4.3 iVMS4200
Software
You will need to install the iVMS4200 software version 2.4.2.55 build161209 onto your laptop. This is required for this
version of the firmware.
4.4 PC/LAPTOP
A Windows PC/Laptop is required to run the iVMS4200 software to programme and setup the Intercom system. The PC in
our example should be connected directly to the KAD LAN2 port. Initially the default factory IP address for the Intercom
devices are: 192.0.0.64/24 (255.255.255.0) and 192.0.0.65/24 (255.255.255.0)
To allow the PC to communicate with the Intercom devices, configured the PC with a primary IP address of 192.168.20.150
(in our example) and a secondary IP address of 192.0.0.250. If you are not sure how to setup a secondary IP address, Google
is your friend
.
