CONTROlS
dixon
-19
Cutting Height Adjuster
The deck cutting height is obtained by pressing the
button on the lift lever and pulling backward to lift the
deck. To lower the deck, push button on the lift lever
and push forward allowing the deck to lower to the
correct cutting height. The cutting height range is from
1½" (38mm) to 4"
(102mm) in ½ (13mm) increments.
The heights are measured from the ground up to the
blade tip with the engine not running.
8050-838
The mower deck’s cutting height adjuster
Throttle Control
The throttle control regulates the engine speed and
thereby the rate of rotation of the blades, assuming the
blade switch is pulled out, see Engaging the Mower
deck.
In order to increase or decrease the engine speed, the
control is moved forward or back respectively.
Avoid idling the engine for long periods, as there is a
risk of fouling the spark plugs.
USE FULL THROTTLE WHEN MOWING
, for best
mower performance and battery charging.
8050-839
Throttle control
8050-839
Choke control
Choke Control
The choke control is used for cold starts in order to
provide the engine with a richer fuel mixture.
for cold starts the control should be pushed to the on
position.
IMPORTANT INFORMATION
In order to obtain an even cutting height it is
important that the air pressure in all four tires
is the same 15 psi (1 bar).
IMPORTANT INFORMATION
Always use the high position to transport.
