1592010401 v2.7 17/10/2008
PROG TOOL KIT
24
3.3.4 HOW TO CREATE AN HOT KEY
Through the PROG TOOL and EASY PROG software is possible
create custom HOT KEY’s.
Wire PROG TOOL to the PC (see paragraph
“PROGRAMMING
FROM PC TO HOT KEY
” page 8).
Modify the desired parameters map (or create a new one) and click
on the icon
(transfer map into Prog Tool)
In the window “Device Model” set the model of the controller you
want to program with the Hot Key and than click OK.
BEWARE:
check carefully that the model of the controller you are
going to program with the Hot Key corresponds to the model the
parameters map belong to. If different the HOT KEY will be
unusable.
EASY PROG will transfer the map into the PROG TOOL.
Plug the empty HOT KEY in the “Hot-Key Copy” connector located
on the front of the PROG TOOL and the push button “Copy”; Led
“copy” starts blinking.
After few seconds Led “copy” stops blinking giving the result of the
operation:
Led “copy” RED =
error during the programming of the HOT KEY,
repeat the operation and if needed replace the HOT KEY.
Led “copy” GREEN =
operation successfully completed; the Hot
Key has been correctly programmed
Remove the new Hot Key.
NOTE:
is now possible to create other copies of the Hot Key by
repeating the above procedure.
