NAME
DATE
DESCRIPTION
REVISION LEVEL
NAME
DATE
DESCRIPTION
REV.
ECN NO.
IN HOUSE ASSEMBLY TEMPLATE
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
DWN
TITLE:
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
300 South Krueger Street
Suring, WI 54174
diversifiedwoodcrafts.com
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
A32 & A37 SERIES
AUXILIARY WORKBENCH
ASSEMBLY INSTRUCTIONS
REV A
5 OF 6
NTS
EMK
9/11/14
NOTE:
1.
EMK
9/11/14
CREATED ASSEMBLY INSTRUCTIONS
A
-
STEP 5:
USING A 4MM ALLEN WRENCH, INSERT THE LEG CONFIRMATS INTO ONE LEG
AND SCREW INTO THE BRACE. REPEAT FOR OTHER SIDE OF BRACE. DO THE
SAME FOR THE OTHER BRACES. MAKE SURE BRACES ARE STRAIGHT AND ALL
THE CONFIRMATS ARE TIGHT.
STEP 6:
INSERT THE STRETCHERS ONCE THE LEG BRACES ARE IN POSITION, ATTACH WITH THE
STRETCHER CONFIRMATS AND TIGHTEN WITH A 4MM ALLEN WRENCH. IF YOU HAVE AN
A32-10W, A32-12W, A37-10W, OR A37-12W, ATTACH STRETCHER TO CENTER BRACE
USING THE STRETCHER BRACKETS PROVIDED. OFFSET BRACKETS ON EACH SIDE OF
STRETCHER SO THE SCREWS DON'T HIT EACH OTHER. PREDRILL HOLES IN STRETCHERS
WITH A
1
8
" BIT AND ATTACH WITH #8 X
3
4
" SCREWS. MAKE SURE EACH LEG BRACE AND
STRETCHER IS TIGHT BEFORE MOVING ON. GO BACK TO STEP 2 AND TIGHTEN UP THE
HANGER BOLTS FOR EACH CORNER LEG USING
1
2
" WRENCH OR
1
2
" SOCKET AND
TORQUE WRENCH, TO A MINIMUM OF 12FT LBS BUT NOT TO EXCEED 17FT LBS .
STEP 4:
(IF YOUR MODEL DOES NOT HAVE 6 LEGS, SKIP TO STEP 5). PUT ONE
OF THE CENTER LEGS IN PLACE AND INSERT THE BOLT, WASHERS,
AND HEX NUT. USING A
1
2
" WRENCH OR
1
2
" SOCKET AND TORQUE
WRENCH, SCREW ON THE NUT BUT AGAIN, DO NOT TIGHTEN ALL
THE WAY. REPEAT FOR THE OTHER CENTER LEG.
CLOSE UP OF CENTER LEG ASSEMBLY
LEG BRACES
STRETCHERS
K:\DIVERSIFIED\ASSEMBLY INSTRUCTIONS\ACAD\A32 & A37 SERIES.dwg, 11/30/2015 7:44:10 AM, DWG To PDF.pc3
