ASSEMBLY TEMPLATE
NOTE:
1.
REVISION LEVEL
EMK
3/15/16
CREATED DRAWING
REV.
A
-
DWN
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
STORAGE CABINET TABLES
STORAGE CABINET TABLES-SINGLE
ASSEMBLY INSTRUCTIONS
REV B
3 OF 3
NTS
EMK
3/15/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
STEP 1:
LAY THE TABLE ON THE FLOOR, WITH APRON SIDE AND BOTTOM OF
CABINET FACING UP. BE SURE TOP ASSEMBLY IS ON A CLEAN SURFACE
TO PREVENT DAMAGE . YOU WILL NEED TWO OR THREE OTHER PEOPLE
TO HELP WITH THIS STEP, AS TOP ASSEMBLY WILL BE HEAVY.
CLOSE UP OF CORNER BRACKET
ASSEMBLY
STEP 2:
INSERT HANGER BOLT ON ONE OF THE LEGS THROUGH THE
CORNER BRACKET AND INSERT LOCK WASHER AND HEX
NUT. TIGHTEN NUT USING A
1
2
" WRENCH OR
1
2
" SOCKET AND
TORQUE WRENCH, TO A MINIMUM OF 12FT LBS BUT NOT TO
EXCEED 17FT LBS . REPEAT FOR OTHER LEG.
TOP
BOTTOM OF CABINET
APRON SIDE
FACING UP
INSERT HANGER BOLT
THROUGH HERE WITH LOCK
WASHER AND HEX NUT
EMK
10/26/16
SEPERATED SINGLE UNITS FROM DOUBLE UNITS
B
-
CLOSE UP OF LEG LEVELER AND LEG
BOOT ASSEMBLY
LEG LEVELER
LEG BOOT
STEP 3:
SLIDE LEG BOOTS ONTO LEGS
WITH FLARED END TOWARD
THE BOTTOM OF LEG. SCREW
LEG LEVELERS INTO T-NUT ON
BOTTOM OF THE LEG.
STEP 4:
TURN UNIT OVER ONTO LEGS. SET TABLE IN PLACE AND ADJUST LEG
LEVELERS TO LEVEL THE TABLE. ATTACH RUBBER MOLDING TO BASE
OF CABINET USING CONTACT CEMENT. AFTER MOLDING IS IN PLACE,
SCREW STAINLESS STEEL CORNER BRACKETS ON EACH CORNER
OVER BASE MOLDING WITH THE SCREWS PROVIDED.
COMPLETE UNIT SHOWN
APPLY RUBBER
MOLDING HERE
11/2/2016 10:51:51 AM, DWG To PDF.pc3
