Dive System – LithiumLed
User Manual Dive System LithiumLed - Version 1.2 English
Page 7
5. ADVERTISMENTS
ATTENTION!!!
Do not point the torch directly in the eyes. Don’t look directly to the light emitted
from the torch, the emitted light could cause serious permanent damages to your sight.
The torch should be stored clean and dry.
Don’t expose the torch to chemical substances. To clean the torch use exclusively fresh water,
paying attention to remove all salt deposits.
The torch was designed for a underwater usage. However if you light on the torch outside the water,
once the torch reaches its temperature limit, the torch switches off automatically thanks to its TSS
system.
ATTENTION !!!
If you light on the torch outside the water the case may reach a temperature in
excess of 50°C.
Do not hit the torch.
Do not expose the torch directly to the sunlight or to heat sources higher than 50°C. Store the torch
in a dry and cool place (5°C/25°C).
Do not try to open, modify or repair the torch on you own, always address it to Dive System or
authorized assistance centres.
Do not screw out the connector cap during diving.
Dive System is not responsible for accidents deriving from an improper usage of the torch.
The warranty is void if the security paint is removed.
6. TECHNICAL CHARACTERISTICS
Laser etched aluminium case.
Very homogeneous light Beam without any chromatic and/or spatial aberrations.
CML System
(“Constant Maximum luminosity”), allows to maintain to 100% the emitten luminous
power for the whole declared autonomy.
BLM System
(“Backup Light Mode”), once the battery is exhausted the luminous power is reduced
to the 20% allowing a backup light for at least 30 minutes.
TSS System
(“Temperature Safety System”), shouts down the torch if it reaches a critical
temperature in order to avoid damages to the torch or to thing beside it.
