1
2
3
2 cm
12-24 V
AC-DC
COM
NC
NO
COM
NO
NC
NO NC
*
*
WEL
1
DAB
1
SPRINT
1
0 1 0
1 5 1
1 1 1
6 3 9
1 1 1
8 2 8
41 5 G1
0 4 0
MOUNTING THE PROFILE
POSITIONING THE MODULES
WIRING
GREEN
BROWN
YELLOW
WHITE
BLACK
PINK
GREY
VIOLET
RED**
BLUE**
POWER SUPPLY
STOP IMPULSE
OPENING SIDE
REVERSE IMPULSE
CLOSING SIDE
TEST OUPTUT***
The transmitter (TX) should be placed next to
the door edges that need to be protected.
The angle adjustment clip should be next to
the transmitter.
Turn the module if necessary.
When a module needs to be turned:
1. detach the clips
2. turn them by 180°
3. reattach
NO POWER
NO DETECTION
DETECTION
The module connected to the door controller
becomes the
MASTER
.
Plug the SLAVE
CABLE between
the modules in
one of the two
placements.
Mount the profiles as close as possible to the closing edge. Leave 2 cm
for the black end caps. Take the position of the white clips into account
before drilling and fastening the screws.
* Output status when sensor is operational
** For compliance with EN 16005 and DIN 18650, connection to door controller test output is required.
*** If door controller is not tested: conncect BLUE to 0 V and RED to +12 V - 30 V DC.
To loosen the modules, please use
a screwdriver.
1
Please refer to specific operator manual