Ditch Witch SK650, Operator'S Manual

Page: 37 / 83

Prepare - 36
SK650 Operator’s Manual
Connect Attachment
CMW
Hydraulic Hoses
If attachment requires hydraulic power for operation, connect hydraulic hoses.
1. Cycle attachment drive control to relieve residual
pressure at hydraulic couplers.
2. Remove dirt and debris from hydraulic couplers.
3. Connect male coupler on attachment to female
coupler (3) on unit.
4. Connect female coupler on attachment to male
coupler (1) on unit.
5. If needed, connect attachment case drain hose to
case drain connector (2).
6. Ensure that connections are secure by pulling on
hoses.
Pressurized fluid or air could pierce skin and cause injury
or death. Stay away.
NOTICE:
• Escaping pressurized fluid can cause injury or pierce skin and poison.
• Before disconnecting a hydraulic line, turn engine off and operate all controls to relieve pressure.
Lower, block, or support any raised component with a hoist. Cover connection with heavy cloth and
loosen connector nut slightly to relieve residual pressure. Catch all fluid in a container.
• Before using system, check that all connections are tight and all lines are undamaged.
• Fluid leaks can be hard to detect. Use a piece of cardboard or wood, rather than hands, to search
for leaks.
• Wear protective clothing, including gloves and eye protection.
• If you are injured, seek immediate medical attention from a doctor familiar with this type of injury.
Hot parts may cause burns. Do not touch until cool.
NOTICE: Hydraulic couplers, hoses and fluid may be hot. Wear gloves when connecting
and disconnecting hydraulic hoses and wait until unit has cooled before touching
hydraulic components.