A�en�on: Before you start assembling your trash receptacle; please prepare a so� surface work area on the floor. The only
tool you will need is a screwdriver. Carefully remove all hardware from packaging and place the hardware parts on the so�
work area where they will not come in contact with the laminated wood components. To avoid damage to the laminated
wood surfaces, keep hardware parts separated un�l they are needed for assembly. 2 PERSON RECOMMENED.
1. Screw 2 cam posts (H2) into the holes in Panel C. A�ach Panel F
to Panel C by inser�ng cam posts into the cam lock holes. Insert 2
cam locks (H1) into cam lock holes on Panel F, use a phillips screw
driver to rotate cam locks clockwise to secure cam posts.
2. Screw 4 cam posts into the holes in Panel D. A�ach Panel A and
assembled Panel C to Panel D. Insert 4 cam locks into cam lock holes
on Panel A and Panel C, use a phillips screw driver to rotate cam locks
clockwise to secure cam posts.
3. Insert 11 cam posts into the pre-threaded holes in Panel B as shown
below. A�ach the assembled panels in STEP 2 to Panel B and use cam
locks to securely lock it in place.
How to join 2 boards with CAM lock:
(a) Insert cam post into flat surface of a board. Fit the hole in the
edge of the joining board over the cam post.
(b) Each cam lock has an open sec�on at the back. Insert the cam
lock into the cam Be sure the opening fits the head of the cam post.
(c) Use a screw driver to turn the cam lock clockwise so it locks onto
the head of the cam post. Do not over �ghten.
(a) (b) (c)
PARTS
A Top Panel
B Side Panel
C Bo�om Panel
D Back Panel
F Toe Kick Panel
G Swing Door
g Li�er Graphic Flip Door
H Divider Panel
1pc
2pcs
1pc
1pc
1pc
1pc
1pc
1pc
HARDWARE
H1 Cam Lock
H2 Cam Post
H3 Wood Screw
H4 Concealed Hinge
28pcs
28pcs
12pcs
2pcs
ASSEMBLY INSTRUCTIONS
TRASH RECEPTACLE - LITTER GRAPHIC
1 of 2
Ver. 03/18