Wood Screw
Hinge Cup
5. Insert 9 cam posts into another Panel B. Install Swing Door G
onto assembled panels with sign facing outside, and hold it at its
place. Assemble the 2nd Panel B with rest panels by inser�ng the
cam posts into corresponding holes.
7. Insert 6 cam posts into the bo�om of Panel A. Place Panel A
on top of the assembled receptacle body, and fit the cam posts
in corresponding cam holes. Insert 6 cam locks and �ghten them
with screw driver.
8. Install concealed hinges.
(a) Press the hinge cup into one flat-bo�omed hole in the door. Be sure
the edge of the hinge is parallel with the edge of the door.
(b) Drive wood screws (H3) through screw holes in the flange to fix the
hinge cup. Secure the other hinge cup in the 2nd bored hole in door.
(c) A�ach the door with hinges assembled with Panel B. Align holes in
the hinge plate with pre-drilled holes in Panel B. Drive wood screws (H3)
into pre-drilled holes to fix the door panel.
10. The assembly is done.
9. Door Adjustments
Open and close the door a few �mes to check the alignments. loosen
or �ghten the hinge adjustment screws as needed to refine the fit of
the door. Turn screws a li�le at a �me un�l the door reaches desired
posi�on and works properly.
Horizontal
Adjustment
Horizontal
Adjustment
Lateral
Adjustment
Lateral
Adjustment
6. Place all Tray Rails (H5) on top of Top Panel A as shown below.
Screw in both ends of Tray Rails with screw (H6) provided from
the bo�om of Top Panel to fix all the metal rails.
H5 Tray Rail
H6 Screw
Wood
Screw
Hinge Plate
2 of 2
Don’t forget to order the rubber liner to finish your receptacle.
Ver. 03/18
