MKT.183.5 | DISPLAX
TM
OQTOPUS USER GUIDE
16
DISASSEMBLE OQTOPUS
DISASSEMBLE THE LEGS WITHOUT OPENING THE TABLE
Unscrew A from C, unplugging the power cable.
Unscrew C from D.
Unscrew E from D.
DETACH THE PCB CONTROLLER
Carefully open the PCB controller drawer, underneath A, with Q.
You will need to disconnect the USB cable and the controller itself.
Very carefully disconnect Ka.
Disconnect K from the ribbon cables. To do so, carefully lift the clamping clip (grey bar) as
shown on the following picture.
K is attached to A using a Velcro strap. Detach K carefully not to damage it. When reattaching
it again, make sure both sides of the Velcro strap match, to ensure it is in the correct position.
DETACH THE GLASS TO ACCESS THE LCD OR CABLES
Unscrew H from A
Take B out, carefully holding by the glass edges. Always place it with the metallic grid facing
down.
08
Clamping clips
Open position
USB
Reset button
