dimension & installation guide
freestanding dishwasher - DX103
page 3
connecTing The Drain hose
• The drain hose must be free of kinks and obstructions.
• The highest point of the hose should not be more than
1 metre from the floor and should have a continous fall.
• The drain hose may be lengthened using additional lengths
and connectors, which can be purchased from Electrolux
Spare Parts.
The extension length must not exceed
2 metres.
Remove internal membrane from drain spigot
When connecting the drain hose to an under sink trap spigot,
the entire plastic membrane must be removed.
Failure to remove all the membrane will result in food particles
building up over time eventually blocking the dishwasher drain
hose spigot.
elecTrical connecTion
WARNING
• Safety standards require the appliance to be earthed.
• Prior to using the appliance for the first time, ensure that
the rated voltage and type of supply on the rating plate
match that of the supply where the appliance is to be
installed.
The fuse rating is also to be found on the rating plate.
• Always plug the mains plug into a correctly installed
approved socket.
• Multi-way plugs, connectors and extension cables must
not be used. This could constitute a fire hazard through
overheating.
• If necessary, have the power outlet replaced. If the
electrical supply cord has to be replaced, contact your local
Customer Care centre.
• The plug must be accessible after the appliance has been
installed.
• Never unplug the appliance by pulling on the cable. Always
pull the plug.
• Ensure that the dishwasher has been tested using the rinse
& hold or quick 30 cycle and that the dishwasher fills with
water, washes and drains with no leaks.
The manufacturer accepts no liability for failure to observe the
above safety precautions.
Remove entire
internal membrane
© Copyright 2007 Electrolux Home Products Pty Ltd ABN 51 004 762 341
DISH303INSTALL_Jul07