4
8. upon the successful binding process of eW1B Battery Level and Signal Level become visible in
ELDES Configuration Tool
software
under Wireless Devices section. if attempt to bind is unsuccessful, try to move eW1B closer to the alarm system device and bind anew.
9. eW1B is ready for use.
NOTE: if you are unable to bind the wireless device, please, restore the parameters of the wireless device to default and try
again. see chapter 6. Restoring Default Parameters for more details.
ATTENTION: the minimum wireless connection range between the wireless device and wireless antenna of eldes alarm sys-
tem can be 0,5 meters.
4. EW1B Zones, PGM Outputs & Tamper
upon successful eW1B module binding process, the system adds 2 wireless
Instant
zones intended for wired sensor connection and 2
wireless PGM outputs intended for electrical appliance connection and control.
the wireless connection loss between eW1B and eldes alarm system leads to system alarm regardless of system being armed or
disarmed. the system identifies this event as a tamper violation and sends alarm by sMs message and phone call to the user (-s) by
default. the sMs message contains the violated tamper number and a star
*
character indicating wireless connection loss as a tamper
alarm cause.
5. Battery Replacement
1. open eW1B enclosure.
2. remove all 3 old batteries from the battery slots.
3. Postition the 3 new 1,5V alkaline aa type batteries according to the appropriate battery slot positive/negative terminals as indicated.
4. insert the batteries into the battery slots.
5. Batteries replaced.
For more details, please, refer to chapter 3. Installation.
6. Restoring Default Parameters
1. remove any battery from eW1B.
2. short circuit (connect) pins d1 and d2.
3. insert the battery back to eW1B.
4. Wait untill led provides several short flashes.
5. remove short-circuit from d1 and d2 pins.
6. Parameters restored to default.
7. Additional Information
Limited Liability
the buyer must agree that the system will reduce the risk of fire, theft, burglary or other dangers but does not guarantee against such
events. “eldes uaB” will not take any responsibility regarding personal or property or revenue loss while using the system.
“eldes uaB” liability according to local laws does not exceed value of the purchased system. “eldes uaB” is not affiliated with any of
the internet providers therefore is not responsible for the quality of internet service.
Manufacturer Warranty
this device carries a 24-month warranty by the manufacturer “eldes uaB”. Warranty period starts from the day the system has been
purchased by the end user. the warranty is valid only if the system has been used as intended, following all guidelines listed in the
manual and within specified operating conditions. receipt must be kept as a proof of purchase date. the warranty is voided if the
system has been exposed to mechanical impact, chemicals, high humidity, fluids, corrosive and hazardous environment or other
force majeure factors.
Safety instructions
Please read and follow these safety guidelines in order to maintain safety of operators and people around:
• DO NOT use the system where it can be interfere with other devices and cause any potential danger.
• DO NOT use the system with medical devices.
• DO NOT use the system in hazardous environment.
• DO NOT expose the system to high humidity, chemical environment or mechanical impacts.
• DO NOT attempt to personally repair the system.
any additional devices linked to eW1B (electrical appliances, relays etc.) must be approved by lst en 60950-1 standard.
