E-VORTEX300-I-0110
Printed in USA
©2010
TVW
Page 4
Safety Guidelines
Safety warnings and guidelines do not by themselves eliminate danger.
They are not substitutes for proper accident prevention procedures and good judgement.
Read and understand this Operator’s Instruction Manual,
and the Engine Manufacturer’s Owner’s Manual
before operating this equipment.
Death of serious injury can result if this machine is used improperly.
Eye and ear protection must be worn at all times while the saw is in use. During normal
operation, sound pressure levels exceed 92dBA. Use only ANSI approved safety glasses
to help prevent eye injury. Standard eyeglasses have only impact resistant lenses; they are
NOT safety glasses.
Operator must wear appropriate clothing and footwear. Do not wear loose clothing or jewelry
that can get tangled in moving parts. Footwear should provide sure footing and protection
from debris that may be dropped. Take steps to insure hair will not be caught in moving parts.
If necessary, tie it back.
•
When loading or unloading the saw, use caution. Make sure rolling table is locked so that the blade will not be
damaged. Do not move the saw while the engine is running.
•
Never exceed the maximum operating speed of the blade. Match the blade speed rating with the arbor shaft
speed.
•
Never leave the saw running unattended.
•
Never operate this saw under the infl uence of drugs, alcohol or when taking medications that impair the senses or
reactions, or when excessively tired or under stress.
•
Do not lend or rent this equipment without including the Operator’s Instruction Manual and the Engine Manufac-
turer’s Manual.
•
Make sure all safety decals can be clearly read and understood. Replace damaged or missing decals immedi-
ately.
Dry cutting creates a large volume of airborne dust. For health reasons, the operator should wear
an applicable respirator. The dust may contain chemicals known to cause serious illnesses, in-
cluding Silicosis - a fatal disease of the lungs. Check the chemical properties of the material to be
cut and follow all EPA/OSHA regulations.
Before Starting:
Operating Instructions
1. Pull up on the foot lever to release the dustpan. Check that the dustpan is completely empty then replace.
CAUTION: Please refer to gasoline engine manufacturers instruction manual, prior to operating vacuum.
2. Check the fuel and oil levels per the enclosed engine manual.
Observe all safety regulations for safe handling of fuel.
WARNING: Do not operate vacuum if there is a fuel leak!
To
order
go
to
Discount-Equipment.com
