5.
Drill a ¼” hole
to dash/panel.
6.
Fit jack threads through hole and secure with included nut (See
Fig. 8
)
Fig.7
Fig. 8
Warning:
Jack may be left freestanding, but to be mounted, ensure
panel is
no thicker than 1/8”
otherwise shaft may not protrude enough
to engage with nut. If necessary, use dremel, sander etc. to thin panel,
Operation
1.
Turn r
adio “ON”
,
2.
P
ress “
TAPE AUX
” or “
CD AUX
“
button
3.
Load a CD or Cassette into slave unit
(This step is required)
4.
Connect audio device to 3.5mm jack using included 3 ft. audio cable or
similar (See
Fig. 9
).
5.
Set audio device to play mode and ensure device volume is set to 80%
or higher.
6.
Audio device will play on car speakers.
Fig. 9
3.5mm audio cable
7.
Use radio volume control button to set playback level.
Warning: Playlist and Track selection is *NOT* possible from radio
buttons. Use audio devices built-in controls to access and control audio
files and selection
8.
To listen to separate or slave unit (CD, Cassette or CD changer), simply
disconnect audio cable (See
Fig. 9
) from jack (See
Fig. 8
) and operate
salve unit as customary. (
Jack must be empty
)
9.
If correct operation is confirmed go ahead and reinstall radio.
