Fig. 4
module
3.
Connect push button 1/8” plug to Module “CTR” jack
(See
Fig. 4
), route
button to front of the dash, remove tape backing, clean are and attach
button to surface (cable is 6ft. long). (See
Fig. 5
)
Fig. 5
push button
5.
Use clip to install microphone to visor or headliner and route cable down
pillar, under dashboard toward module location and connect to module
“MIC” input
.
Exercise caution when routing microphone so to not damage the
cable. Also ensure no ventilation duct is pointed towards
microphone
.
Microphone
Fig. 6
Optional push button with built-in microphone
:
For added installation flexibility, we offer optional push button with built-in
microphone seen in images below. This option
replaces
conventional visor
microphone and separate push button shown in
Fig. 5
and
6.
ages; which
means button can be placed on dashboard within driver reach or custom
installed nearby. C
onnect 1/8” plug to module “
MIC/CTR
” jack (See
Fig. 4
),
route to dash area (cable is 6ft. long); clean surface, remove tape backing and
attach to dash. (To add this option to cart, simply tap option on order page)
6.
Disconnect (car side) 8-pin plug from radio 8-pin connector (See
Fig. 7
)
Fig. 7
Radio harness 8-pin connectors
