Fig. 2
10-pin connector
4.
Connect Red Acc. wire to switched/Acc. supply in vehicle. One possible
option is tapping radio power/speaker harness at
pin 12 (
See
Fig. 4)
(wire color varies, from white, pink, etc.) however pin 12 is one possible
accessory source.
Another possible source is fuse panel or cigar lighter plug.
Warning;
Red wire must only be connected to accessory/switched
supply. Permanent/Battery supply will drain car battery and is not
recommended.
Fig. 4
5.
Secure module and proceed to next step.
Pairing
Pairing process varies from phone to phone but basic steps are the same. This
process is done upon initial install and will not have to be repeated
1.
Turn Ignition and Radio “ON”
LED inside adapter peephole will flash (pairing mode)
2.
On A2DP device: Go to
Settings, Wireless & Networks, Bluetooth
Settings
3.
Select
Bluetooth
and turn on.
4.
Then select Bluetooth settings
5.
Tap
Scan for devices
.
6.
Wait for the Bluetooth device name to appear and select it. (See below)
LED inside adapter peephole will glow steady (paired)
