14
Operating Instructions
Preparation for Operation
THIS UNIT WAS SHIPPED WITHOUT OIL IN THE
ENGINE. Check the oil level before each operation.
Fill Engine with Oil
1. Add oil according to engine manual. Do not overfill. Use
SAE30 engine oil.
Do not mix oil with gasoline.
Oil level
must be full. Check the oil level by removing oil fill plug
(se
e
Figure 5
). Oi
l level should be up to the bottom of the
fill plug opening.
Pre-Start Inspection
1. Make sure safety shields are in place and nuts & bolts are
secure.
2. Check oil level.
3. Inspect air cleaner. Clean or replace it as needed.
4. Check fuel supply. Fill the fuel tank no closer than 1 inch
from top of tank to provide space for expansion.
5. Be sure spark plug wire is attached and is tightened securely.
6. Examine underneath and around engine for oil or fuel leaks.
7. Inspect fuel hoses for tightness and fuel seepage.
8. Look for signs of engine damage.
9. Remove excessive debris from muffler area and recoil starter.
Adjusting the Depth Regulator
NOTE: The depth regulator is shipped upside down.
The depth regulator determines the depth of the cultivating
blades. Adjust according to the desired working depth. Soil
types that are very hard may require using the cultivator in
several passes, going in different directions with the depth
regulator set at deepest position to ensure the soil has been
properly worked through
. (
Figure 6
)
!
WARNING
Figure 5
FUEL FILL
AIR FILTER
COVER
OIL
FILL
Figure 6
PULL PIN TO ADJUST
DRAG STAKE HEIGHT
