11
Operating Instructions
Adjusting the Depth Regulator
Remove the locking pin and reverse the depth regulator and wheels,
slide up or down to position at desired tilling depth and reinstall the
locking pin (see Figure 4).
Starting the Engine
Make sure that the cultivator is on a level, stable position before starting
the engine. Do not start the engine if there is spilled fuel.
1. Turn the engine’s ON/OFF switch to ON (see Figure 5).
2. Pump the engine primer bulb until it fills with fuel.
3. Turn the engine’s choke lever to the CLOSED position. Set the
choke lever to the OPEN position only when the engine has
started or upon restarting a warm engine.
4. Pull the recoil starter handle slowly until you meet some
resistance. Pull the recoil starter with a rapid full arm stroke
allowing the starter rope to rewind slowly. Repeat as necessary
until the engine starts running.
5. After the engine warms up and starts running normally, move
the choke lever to the OPEN position.
Note: Allow the engine to warm up for 30 seconds before moving
the choke lever to the OPEN position.
5. The first 25 hours of operation is the break-in period. Breaking-
in the Engine will help ensure proper equipment and engine
operation, and will extend the engine’s lifespan. After the first 25
hours of use change the gasoline/2-cycle oil fuel mixture.
Pulling the safety
drive lever towards the
handlebar engages the
tines.
Figure 5
On/Off
Switch
LOCKING
PIN
DEPTH
REGULATOR
Figure 4
