23
DINAMIC 1.1
dirna
, s.a.
EN
OPERATIONS VALID FOR ALL MODELS
8
9
On the studs, thread (4) M6 nuts with (4) flat
washers Ø 6, which should be level with the
cover.
SEE ATTACHED DIAGRAM
Pass the waste water pipe through the bore of
the evaporator base and connect to the tray.
8
9
10
Pass the cabling through the Ø 35 bore
towards the exterior.
10
10
M6 Nut
Wide ring
flat washer
M6 Nut
(leave at
upholstery height)
Evaporator
base
Upholstery
M6 Nut
Lorry sheet
M6 self-blocking
nut
Protector cap
Rubber washer
Wide ring
flat washer
Wide ring flat
washer
M6 Stud
OUTSIDE
INSIDE
VERY IMPORTANT
In the case of slanting upholstery, the evaporator
unit must be vertical or sloping from the lower
section to the outside in order to prevent the
condensation water from dropping onto the
upholstery.
Wastewater
tray
Evaporator
bracket
Upholstery
!