Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Plug the 5V power adapters to the power jack of the transmitter and receiver.
Ensure the Power LED ON (Green) and Status LED blinking slowly (Green).
Figure 2
– Connection of power adapter to the transmitter and receiver
Step 3
Please, check if the maximum resolution of the display is UXGA (1600x1200).
Otherwise, follow the instructions for
Self-EDID Programming Procedure
on
page 1-5.
Step 4
Connect SC optical fiber between the transmitter and the receiver as shown in
figure 3.
Figure 3
– Connection of optical fiber
Note:
Both single and multi-mode fibers are applicable to DVFX-110-TR. The
maximum extension length by single mode fiber is 1,000meters and
500meters by multi-mode.
1-3 Installation
DVFX-110
Transmitter
DVFX-110
Receiver
One
(1)
Opt
ical
Fibe
r
Step 5
Plug the transmitter to the DVI receptacle of the DVI source such as PC and the
receiver to the DVI receptacle of the display.
Figure 4
– Connection of the transmitter to the DVI source and receiver to the display
Note:
Be recommended NOT to use any intermediate cable or adapter between
them to avoid undesirable performance degradation.
Step 6
Make the PC and the display power ON. And ensure that the Status LED in
transmitter and receiver turn on.
By using an optical splitter OPS-xyz, one (1) signal from
DVFX-110
transmitter
can be copied up to sixteen (16) times as shown in figure 5. For more
information, please refer to user
’s manual of OPSR-2, OPX-xyz.
Figure 5
– Connection diagram using optical splitter, OPS-104S
Note:
The maximum extension length can be shortened by using optical splitter
and additional fibers. The single-mode fiber is only applicable to OPS-xyz.
1-4 Installation
DVI Source
DVFX-110
Transmitter
DVI Display
DVFX-110
Receiver
DVI Display 2
DVI Display 3
DVI Display 4
DVFX-110
Tx
DVFX-110
Rx
OPS-104S
One (1) Optic
al Fi
be
r
Up to 1.5Km at WUXGA
DVI Source
DVI Display 1
