Direction-
Plus™
PLPV621DPK_Install
Page | 8
14.
Mount the PL150DP Pre-filter assembly to the mounting bracket using the 2 x 10mmx30mm bolts, 2 x 10mm flat
washers.
15.
Remove the RED quick disconnect fitting from the original filter head (the larger lower fitting) and the other end of the
pipe coming from the tank. Remove the factory piece of pipe. Keep this pipe in a safe place as it will be needed if the
vehicle needs to be return to factory specification
16.
With one end of the supplied 10mm fuel hose, Lubricate the inside portion of one end using diesel fuel or WD40
17.
Install one of the 10mm 90° push-lock fittings into the pre-lubricated end of the 10mm fuel hose, ensuring that the hose
stops firmly against the inside of the bell cover.
18.
Connect the 10mm 90° push-lock fitting to the inlet of the pre-filter housing. Adjust the angle of the fitting tail to clear
any obstructions.
19.
Route the 10mm fuel hose down to the steel fuel pipe that was connected to inlet of the factory fuel filter and cut the
hose to length approximately 25mm past the end of the steel fuel pipe
20.
In the end of the same piece of fuel hose, install one of the 9.89mm female quick disconnect fitting and secure with a
hose clamp. Connect this hose to the supply line from the tank.
21.
With the remaining length of 10mm fuel hose Lubricate the inside portion of one end using diesel fuel or WD40.
22.
Install the last 10mm 90° push-lock fitting into the pre-lubricated end of the 10mm fuel hose, ensuring that the hose
stops firmly against the inside of the bell cover.
23.
Connect the 10mm 90° push-lock fitting to the outlet of the pre-filter housing. Adjust the angle of the fitting tail to clear
any obstructions.
Factory fuel filter
inlet connection
