17
Directed Digital System FORD9
© 2016 Directed. All rights reserved.
Module reset
A module reset will only erase the steps perfomed in "Module programming" on page 13. All settings
(firmware) and settings flashed to the module using the web configuration tool will not be affected.
1
If required for your installation, connect both black16-pin and white18-pin
harnesses, as well as the white 7-pin harness to the module. Press and
hold the programming button, then connect the white 12-pin harness to
the module.
1
st
4
th
3
rd
2
rd
5
th
2
Wait 3 seconds until the LED turns ON solid orange then release the
programming button. The LED turns ON solid red.
Solid
Solid
&
&
Release
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some
settings may need to be reconfigured. Connect your module to a computer and use the web configuration tool to
edit its programmable features.
1
If required for your installation, connect both black16-pin and white18-pin
harnesses, as well as the white 7-pin harness to the module. Press and
hold the programming button, then connect the white 12-pin harness to
the module.
1
st
4
th
3
rd
2
rd
5
th
2
After 3 seconds the LED turns ON solid orange. Keep holding the
programming button until the LED flashes red, then orange slowly.
Hold
Flashes
Solid
&
&
3
Release the programming button. The LED turns ON solid red.
Solid
&
Release
