14
Directed Digital System FORD9
© 2016 Directed. All rights reserved.
11
By default, the tachometer is preprogrammed for the
vehicle. For instructions on how to program tach, refer
to the Analog Installation Guide, which can be found
on www.directechs.com.
Initialize
tachometer
You may now proceed to the Web programming (for
Key2Go) section.
* Your aftermarket remote may differ from the model shown in the illustrations.
Web programming (for Key2GO)
Refer to "LED diagnostics and troubleshooting" on page 15 for more information and for troubleshooting
purposes.
Version 4.5 or higher of XpressVIP must be installed on your computer to complete this programming sequence.
To connect the module:
1
Disconnect the module and complete the Key2GO procedure (see
below).
2
Remove the module from the vehicle and reconnect it to your
computer. The XpressKit web site will automatically recognize that you
are moving onto the second phase of the programming sequence.
3
Select the method and click on Submit Key2GO Request.
4
Once rthe configuration is completed, reconnect the module. The LED
turns solid green for 2 sec, then OFF.
&
Solid
Green x3 sec.
OFF
You have successfully completed the module programming sequence.
* Your aftermarket remote may differ from the model shown in the illustrations.
