
Soft reset
A module reset will only erase the steps performed in "Module programming with CAN connection" on page 69. The firmware
and settings flashed to the module will not be affected.
1
If required for your installation,
connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power harness.
Press
and
hold
the programming button, then
connect
the 12-pin harness to the module.
Connect all but the
12-pin harness
2
Wait
3 seconds until the LED turns ON solid orange then
release
the programming button.
The LED turns ON solid red.
&
&
Release
Solid
Solid
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings may need to
be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.
1
If required for your installation,
connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power harness.
Press
and
hold
the programming button, then
connect
the 12-pin harness to the module.
Connect all but the
12-pin harness
2
After 3 seconds the LED turns ON solid orange.
Keep holding
the programming button until
the LED flashes red, then orange slowly.
Hold
Solid
Flashes
&
&
3
Release
the programming button. The LED turns ON solid red.
Release
&
Solid
73
Directed Digital Solutions HONDA4
© 2020-01-03 Directed. All rights reserved.