4
DS4+ FORD1
© 2018-01-12 Directed. All rights reserved.
Introduction
The FORD1 firmware for DS4+ is compatible with specific Ford, Lincoln and Mercury vehicles. It is a complete
solution for remote start, security (when security features are enabled), bypass, and features built in Bluetooth
4.0 allowing you to configure and control your system. This guide provides information on the installation of the
module using FORD1. Please refer to the DirectLink application or www.directechs.com for more information
about which configuration is best for your application.
Warning!
This module is designed to be configured using the DirectLink application for mobile devices, however it can also
be configured using the web tool located at www.directechs.com. To download the DirectLink mobile application, please visit the
Google Play or Apple store.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Keys required for
programming
2
Keys required for
operation
0
Compatible with FORD1 4.13+
Key2GO is required if only one key is available. You can program the interface without the need for Key2GO if two keys
are present.
Keys required to program: 40-Bit Encryption transponder: Programming can be completed with two (2) keys or with one (1)
key if using Key2GO.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
It is important to check that the fuses are positioned correctly in the module. Refer to the "Fuse selection" section following
each installation type for more information.
Refer to the "Vehicle wiring reference chart" following each installation type.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with a factory hood pin.
[2]
The siren is
ONLY
required when enabling the security features during module flashing.
[3]
The Green wire is
ONLY
required for starter disable and anti-grind connections.
[4]
Keysense or Factory Disarm Output is required
ONLY
if the vehicle is equipped with an OEM Alarm. Refer to the "Vehicle
wiring reference chart" following each installation type.
[5]
CAN connections are only required if using in conjunction with SmartStart.
[6]
Required
ONLY
when enabling the security features during module flashing.
[7]
Vehicles built after July 24, 2000.
Additional parts required (maximum required):
Diode 6A
0 x 1A Diodes
86
85
30
87a
87
0 x Relay
Resistor 100
Ω
0 x Resistor
Fuse 7.5A
0 x Fuse