Remove the key from the ignition.
Key OUT
O
F
F
START
IG
N
Page 10
Module Programming
Refer to the
LED Diagnostics
section for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the
XKLoader2
.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the
year
,
make
and
model
of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select one of the available install options (config for RSR, RXT or Standard install), and follow the
instructions provided on the screen.
5. Once you have configured your options, click on the
FLASH
button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
“The flashing is successfully completed. You may now unplug the kit.”
You can now proceed with the programming instructions below.
Warning!
2
Solid
The LED turns ON solid red.
1
OR
If required for your installation, connect the 10-pin, 12-pin
and 14-pin harnesses to the module, then connect the 4-pin
D2D harness.
D2D Installation
If required for your installation, connect the 10-pin and 12-pin
harnesses to the module, then connect the 14-pin harness to
the module.
W2W Installation
10-p
in
D2D
st
1
12-p
in
14-p
in
nd
2
rd
3
10-p
in
D2D
st
1
th
4
12-p
in
14-p
in
nd
2
rd
3
5
4
3
6
Press the Unlock button on the OEM remote and wait until the
LED starts to flash orange.
Make sure the driver’s door is open.
Remove the key from the ignition barrel. The LED will keep flashing green.
Turn the key to the IGN position. The LED will start to flash green.
Steps 5 to 7 must be executed within 5 seconds.
&
&
&
Key IN
O
F
F
START
IG
N
Key OUT
O
F
F
START
IG
N
Flashes
Flashes
Flashes
7
Insert and turn the key back to the IGN position. The LED will
change to solid green for 3 sec. then OFF.
&
Key IN
O
F
F
START
IG
N
Solid
Press
Unlock button
Rev.: 20130304
Platform: DBALL
Firmware: GM10 v. 2.08+
© 2012 Directed. All rights reserved.
