5
933.SUBARU2 1.38.195.3 2010 Subaru Outback
©2022 VOXX•DEI LLC. All rights reserved.
Pre-installation and application warnings
START
HERE
This section highlights important information for this specific firmware and will assist in pricing accordingly, as
well as bringing awareness to any operational or vehicle limitations.
Compatibilities and Requirements
T-Harness
compatible
THSUN1
Keys required for
programming
1
Keys required
for operation
0
Vehicle Takeover
Refer to the
Quick Reference Guide
section for more details.
Firmware notes
T-Harness (THSUN1):
•All T-Harness wires not listed in the diagram are not required for the installation. Loose wires such as Siren Output and
Hood Input may need to be pulled from the tapped section of the T-harness. Refer to the "wiring diagram with T-Harness"
for more information on connections and installation instructions.
•The optional Plug & Play
THSUN1
T-Harness is sold separately.
•The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
•All T-Harness wires not listed in the diagram are not required for the installation.
DS3+/DS4+ module:
Required for this installation, as the relay harness (H2), 10-pin white connector is used.
RKE feature:
On certain vehicles, the SPECIAL RKE feature must be enabled when flashing the module to enable the OEM remotes
during runtime.
Key2GO:
Mandatory to control the immobilizer override in this firmware.
Fuses:
It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on each wiring
diagram.
All connectors are displayed from the wire side (unless specified otherwise).
Refer to the "Vehicle connections" following the installation diagram.
Footnotes
[1]
Hood pin:
The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory
hood pin, or if not supported in data.
[2]
Siren:
The siren is only required when enabling the security features during module flashing.
[3]
Green wire:
The green wire is only required for starter disable and antigrind applications.
[4]
Keysense connection:
Only needed if keysense is not recognized through data at the time of programming. Refer to the
"LED diagnostics & Troubleshooting" section for more details.
[5]
Key Release Output:
Only required for Pit Stop mode or manual transmission vehicles.
[6]
External relay:
When using an external relay, use a 1N4002 diode or larger.
[7]
Clutch Output
: Connection required only for manual transmission.
[8]
THSUN1:
When using the THSUN1 T-harness, an external relay is required for (-) Negative clutch connection.