5
403.CHRYSLER6 2.14 2014 Dodge/Ram 3500
©2022 VOXX•DEI LLC. All rights reserved.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
THCHD3 (Rev. 1 to 2)
Keys required for
programming
1
Keys required for
operation
0
The optional Plug & Play
THCHD3 (Rev. 1 to 2)
T-Harnesses are sold sparately.
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
The keyless entry control on the OEM Key FOB used during Key2Go programming will not work while the vehicle is remote
started.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Refer to the "Vehicle connections" section following the wiring diagram.
General notes:
This section highlights important information for this specific firmware.
[1]
The Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[2]
The RAP Off connection is
ONLY
required if
NOT
supported in data.