Directed Electronics Rattler 431R Series, Owner'S Manual

Page: 16 / 28

12
©
2000 Directed Electronics, Inc.
ceases, the system will resume normal monitoring. For example, if
your vehicle has an interior light exit delay and you arm the sys-
tem before the light turns off, you may hear a Bypass Notification
chirp. Three seconds after the light turns off, however, normal
monitoring resumes.
NOTE: Bypass Notification does not occur when the system is in Silent
Mode ™ or if the chirps have been programmed not to sound.
Your system has a Tamper Alert feature that notifies you of system
triggers that occur while you are away from your vehicle. If you
hear four chirps when you disarm, this indicates that the system
was triggered in your absence. If you hear five chirps when you
disarm, this indicates that a specific zone was triggered so many
times that the NPC ™ has bypassed that zone. In both cases, the
pattern of the flashing status LED indicates which zone was trig-
gered (see Table of Zones). The LED does not, however, report when
Warn Away Responses have activated; it only reports Triggered
Sequences. The system retains this information in its memory and
will continue to chirp four or five times each time the system is
disarmed, until the next time the ignition is turned on.
A zone is represented by the number of LED flashes used by the
system to identify a particular type of input. Standard input assign-
ments are listed in the following table, along with spaces to write
in any optional sensors or switches that you have had installed.
Table of Zones
Disarming Diagnostics