5
54
4
© 2005 Directed Electronics, Inc. Vista, CA
2. Was the Tach Learn successful? The LED must light solid and bright to indicate a successful learn.
3. Make sure that there is a tach signal at the purple/white tach input wire of the remote start. If there is not
a tach signal, recheck the connection to the vehicle’s tach wire and make sure the wire is not broken or
shorted to ground leading to the remote start.
■
TTh
hee vveeh
hiiccllee w
wiillll ssttaarrtt,, b
bu
utt w
wiillll o
on
nllyy rru
un
n ffo
orr 1
10
0 sseecco
on
nd
dss..
1. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this
does not work, a tach wire should be used.
2. Check diagnostics.
■
TTh
hee cclliim
maattee cco
on
nttrro
oll ssyysstteem
m d
do
oeess n
no
ott w
wo
orrkk w
wh
hiillee tth
hee u
un
niitt iiss o
op
peerraattiin
ng
g tth
hee vveeh
hiiccllee..
Either the wrong accessory wire is being energized or more than one ignition or accessory wire must be ener-
gized in order to operate the climate control system.