7
© 2011 Directed Electronics. All rights reserved.
Remote Start, (H3) 10-pin connector
H3/1
PINK
(+) IGNITION 1 INPUT/OUTPUT
H3/2
RED/WHITE
(87) FLEX RELAY +12V INPUT (30A FUSED)
H3/3
ORANGE
(+) ACCESSORY OUTPUT
H3/4
VIOLET
(+) STARTER OUTPUT (CAR SIDE OF THE STARTER KILL)
H3/5
GREEN
(+) STARTER INPUT (KEY SIDE OF THE STARTER KILL)
H3/6
RED
IGNITION 1 +12V INPUT (30A FUSED)
H3/7
PINK/WHITE
(30) FLEX RELAY OUTPUT (car side of ign, acc or starter wire)
H3/8
PINK/BLACK
(87a) FLEX RELAY INPUT (key side of ign, acc or starter wire if needed)
H3/9
RED/BLACK
ACCESSORY/STARTER RELAY +12V INPUT (30A FUSED)
H3/10
NC
No Connection
Door Lock, 3-pin connector
1
BLUE
(-) 500mA UNLOCK OUTPUT
2
EMPTY
NOT USED
3
GREEN
(-) 500mA LOCK OUTPUT
Adjusting the Sensor
Important!
Make sure the vehicle is disarmed. The shock sensor sensitivity can be adjusted by using a trimmer
tool to turn the potentiometer.
Adjusting the sensor:
1.
Disarm
the system,
turn
the ignition Off.
2. With the sensor mounted in its permanent location, locate the trim pot on the shock sensor module and
using a trimmer tool:
• Turn the potentiometer clockwise for increased sensitivity or
• Turn it counterclockwise for decreased sensitivity
Note:
You can test the new setting by cautiously impacting the vehicle with increasing intensity while not-
ing the LED status on the shock sensor. The LED turns on for a short duration for small impacts before turn-
ing off (indicating a warn-away trigger). The impact level required to fully trigger the alarm is indicated
when the LED remains on for a longer duration before turning off.
Note: This adjustment cannot be performed using the remote control.
Initializing Virtual Tach (not needed w/hardwire tach inputs)
To program Virtual Tach:
1. After the install is complete,
remote start
the engine. The programming operation may require 3 cranks of
the starter before the engine starts and runs. Do not turn off the remote start if this happens, it is a normal
programming operation.
2. Once the engine begins running, let it run for at least 30 seconds.
3. Using the Remote, send the Remote start command to turn remote start off. Virtual Tach is programmed.
To reset Virtual Tach, go into the
Reset and Deletion
section of this guide. Virtual Tach
cannot
be reset with
the Bitwriter.
Note:
Virtual Tach cannot be used in MTS Manual Transmission Mode. It is also not recommended for diesel
trucks.
