7
© 2003 Directed Electronics, Inc
1. RRCCAA OOuuttppuutt JJaacckkss - These pass
through RCA jacks can be used to
send a signal to a second amplifier.
2. RRCCAA IInnppuutt JJaacckkss - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
3. IInnppuutt GGaaiinn AAddjjuussttm
meenntt - Controls
amplifier sensitivity and is used to
match the input level of the ampli-
fier to the output level of the signal
source.
4. PPhhaassee SSw
wiittcchh - Changes the phase
of the subwoofer speaker output by
180 degrees.
5. CCrroossssoovveerr FFrreeqquueennccyy AAddjjuussttm
meenntt -
Adjusts the crossover point for the
on-board active crossover.
6. BBaassss EEQQ SSw
wiittcchh - Adds an additional
8 db of boost to the subwoofer
output when on.
7. SSttaattuuss LLEEDD - Will light GREEN to
indicate the amplifier is on and
operating normally, and will be off
if the amplifier shuts down due to
short circuit, or DC offset. The LED
will remain on and output will
cease if the amplifier overheats.
8. RReem
moottee SSuubb LLeevveell CCoonnttrrooll - Controls
the subwoofer amplifier gain
controls from a remote location for
ease of adjustment during listening.
W
Waarrnniinngg:: DO NOT connect a level control knob from other
manufacturers to the Remote Sub Level Control of
any Directed amplifier. Even though the connectors
fit properly, the control knob and connector pin
positions may be different and the amplifier will be
damaged.
FRONT PANEL CONNECTIONS/CONTROLS
OUTPUT
INPUT
BASS EQ.
PHASE
GAIN
FREQ
R
L
MIN
30
MAX
250
OFF
0
ON
180
POWER
FIGURE 1—AMPLIFIER CONNECTIONS 350d FRONT
7
2
6
4
3
8
1
5
Summary of Contents for 350d
Page 1: ...model 350d ...
