6
© 2002 Directed Electronics, Inc
1. RRCCAA OOuuttppuutt JJaacckkss - These pass
through RCA jacks can be used to
send a signal to a second amplifier.
2. RRCCAA IInnppuutt JJaacckkss - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
3. SSttaattuuss LLEEDD - Will light GREEN to
indicate the amplifier is on and
operating normally and will be off if
the amplifier shuts down due to
short circuit, DC offset, or over-
heating detected by the on-board
protection circuitry.
FRONT PANEL CONNECTIONS/STATUS LED
OUTPUT
INPUT
R
L
POWER
FIGURE 1—AMPLIFIER CONNECTIONS 2400 FRONT
2
1
3
speaker load, the more heat is
generated. For low impedance
speaker applications or restricted
ventilation installations, an external
cooling fan may be advisable.
9. Battery and ground connections to
the vehicle should be made with
crimped ring terminals of the appro-
priate size (surface area is what
counts); soldering the terminals
after crimping is also recom-
mended.
10. Due to the high-frequency MOSFET
switching power supply, filtering the
power cable is not generally
required (remember that the amp
can’t deliver full output if the power
supply is restricted). Proper
grounding of the signal source is
mandatory for the amplifier to
reach its performance peak. If the
RCA inputs are not grounded
adequately via the signal source,
electrical noise from the vehicle
may be picked up in the system.
Summary of Contents for 2400
Page 1: ...model 2400 ...
