7
© 2002 Directed Electronics, Inc
1. RRCCAA OOuuttppuutt JJaacckkss - These pass
through RCA jacks can be used to
send a signal to a second amplifier.
2. RRCCAA IInnppuutt JJaacckkss - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
3. IInnppuutt GGaaiinn AAddjjuussttm
meenntt - Controls
amplifier sensitivity and is used to
match the input level of the ampli-
fier to the output level of the signal
source.
4. CCrroossssoovveerr SSeelleeccttiioonn SSw
wiittcchh -
Controls the type of filter for the on-
board active crossover. FLAT does
not attenuate any frequencies and
is for full-range speaker systems.
HPF attenuates low frequencies and
is used for mid-range speakers and
tweeters. LPF attenuates high
frequencies and is used for
subwoofers speakers.
5. CCrroossssoovveerr FFrreeqquueennccyy AAddjjuussttm
meenntt -
Adjusts the crossover point for the
on-board active crossovers.
6. BBaassss EEQQ SSw
wiittcchh - Adds an additional
8 db of boost to the speaker output
when on.
7. SSttaattuuss LLEEDD - Will light GREEN to
indicate the amplifier is on and
operating normally, and will be off
if the amplifier shuts down due to
short circuit, DC offset, or over-
heating detected by on-board
protection circuitry.
FRONT PANEL CONNECTIONS/CONTROLS
OUTPUT
INPUT
BASS EQ.
FREQ
GAIN
R
L
50
MIN
500
MAX
LPF
HPF
FLAT
OFF
ON POWER
FIGURE 1—AMPLIFIER CONNECTIONS 2150 FRONT
2
7
6
5
4
3
1
Summary of Contents for 2150
Page 1: ...model 2150 ...
