1-800-634-7328
■
directsupply.com
5
Directions for Use
Directions for Use
•
Note: Prior to initial operation, the nebulizer should be thoroughly cleaned.
Step 1: Place your compressor nebulizer on a flat and stable surface. Be sure that
you can easily reach the controls when you are seated.
Step 2: Open the clear cover and remove the inside accessories.
Note: Prior to initial operation, the nebulizer should be thoroughly cleaned
referring to the “Cleaning” section in this manual.
Step 3: Gently twist the top part of the nebulizer counter-clockwise to disassemble
the nebulizer.
Step 4: Fill the bottom section of the nebulizer with the medication prescribed by
your physician. Be sure that the cone is put inside the bottom section.
Step 5: Gently twist the top part clockwise to re-assemble the nebulizer. Be sure
the two sections fit well.
Step 6: Attach one end of air tube to the base of the nebulizer.
Step 7: Attach the other end of air tube to the air tube connector located on the
front of the compressor.
Step 8: Attach to the top section of nebulizer.
Step 9: Plug the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at “OFF” status.
Step 10: Press power switch to begin your prescribed treatment.
•
Note:
The compressor motor has a thermal protector which will shut off the unit before
the unit is overheated. When the thermal protector shuts the unit off, please:
a) Switch off the unit.
b) Unplug the unit from the electrical outlet.
c) Wait 30 minutes for the motor to cool down before another treatment. Make
sure the air openings are not obstructed.
Step 11: When treatment is finished, shut off the unit and unplug it from the
electrical outlet.