Part 1 - Remote Setup
18
Exposure
Configure
Exposure
settings.
•
AE Target Gain
: Specify exposure compensation’s
target gain. Exposure is compensated automatically
based on the specified target gain. Higher the gain,
brighter the images.When using WDR, flickering can
be present in poor environments even if Anti-Flicker is
turned on.
•
Anti-Flicker:
If the lights in the area where the
camera is located use alternating current, specify
the frequency of the lights to minimize flickering.
Matching the frequencies can reduce flickering.
(NTSC: 60Hz, PAL: 50Hz) When using WDR, flickering
can be present in poor environments even if Anti-
Flicker is turned on.
Depending on the camera module, WDR may not
work properly if Anti-Flicker and WDR are used
together. Please use only one of them in the camera
module.
•
Slow Shutter
: Activate
Slow Shutter
. The electronic
shutter’s speed will decrease to the specified level
under low-lighting conditions to allow more light in
and therefore produce brighter images.
•
WDR:
Disables or enables the WDR(Wide Dynamic
Range). When the very dark and very bright areas
exist simultaneously on the screen, WDR allows you to
recognize the both areas.
When using WDR, the maximum bit rate of H.264
/ JPEG is limited to 6Mbps. (2M maximum image
quality is limited to standard image quality.)
•
Backlight Compensation
: Enable/disable the
Backlight Compensation feature. If WDR used,
Backlight Compensation OFF does not work.
-
ON
: When images are too bright overall due to
backlight, objects are exposed brighter under
backlight circumstances.
•
Exposure Control:
Adjust Shutter Speed and gain.
This option is available only when
Anti-Flicker
and
Slow Shutter
are both set to
Off
.
-
Auto:
The system will assess the lighting
conditions and adjust the shutter speed and gain
automatically.
-
Manual:
Use the slider to select the desired shutter
speed and gain. Select the most suitable minimum
and maximum shutter speeds and gains for the
lighting conditions in the area where the camera is
located.
With certain features, selecting
Auto
automatically
loads settings suitable for the camera's installation
environment.